![]() |
High Performance Cast Elastomers |
Neuthane EH 85 - MDI - Hybrid PPG Polyurea System |
Technical information on NEUTHANE 85 System can be found by scrolling down the page ↓
TDS (Technical Data Sheet) PDF version
These may be downloaded by clicking link
and will open with your PDF reader in a new window [and can be saved]
Neuthane™ EH 85 MDI - Hybrid PPG Polyurea System
Properties
This is a high-performance MDI-PPG Polyurea system used for Spray Applications
They offer
- High abrasion and wear resistance
- Rapid reactivity (seconds)
- Continuous, Waterproof film
- High resistance to corrosion and chemicals
- Vertical and horizontal applications
- No risk to the environment
Typical Applications
- Tank coatings and linings
- Pipe / Pipeline coatings
- Flooring and Parking Decks
- Bridge deck Coating
- Water Parks and Playgrounds
- Fuel storage and containment
- Aquarium Lining
- Roof Coatings
- Joint-fill / Caulk
- Manhole and sewer linings
- Waste water treatment linings
Processing by dispensing machine
Machine processing
- Process ISO at 75°C
- Process Poly at 75°C
- Hose at 80°C
- ISO Pressure at 2000 - 2200 psi
- Poly Pressure at 2000 - 2200 psi
Special considerations
Processing
- Pails or Drums must be melted and rolled so material is fully mixed before use
- Avoid moisture contamination of all materials
- Part used containers should be flushed with dry nitrogen and resealed immediately after use
Storage
Store for 12 months in the original packing. Keep the orginal drums tightly closed to prevent contamination by humidity in a clean, dry environment at temperature between 10 and 30°C.
Add dry nitrogen to already opened drums.
[printfriendly]
![]() |
High Performance Cast Elastomers |
Neuthane EH 85 - MDI Hybrid PPG Polyurea System |
Hardness | DIN 2240-91 | Shore A | 85 |
DIN 2240-91 | Shore D | ||
100% Modulus | BS 903 Pt2 A2 - ISO 37 | lb/in2 (Mpa) |
861 (5.9) |
300 Modulus | BS 903 Pt2 A2 - ISO 37 | lb/in2 (Mpa) |
1870 (12.9) |
Tensile Strength | BS 903 Pt2 A2 - ISO 37 | lb/in2 (Mpa) |
2310 (16) |
Elongation at Break | BS 903 Pt2 A2 - ISO 37 | % | 350 |
Tear Strength | BS 903 Pt2 A3 - ISO 34-1 | lbf/in (kN/m) |
300 (52.5) |
Abrasion loss | DIN 53516 | mm2 | <50 |
Resilience | ASTM D 2632-92 | % | - |
Specific Gravity | g/cm2 | - |